12/28/2023 0 Comments Harmony hub winkHere is the link to my modified script and its also run using the same technique as the previous script from rc.d. Longer sleep between each run - I do 9 sec sweeps, this doesn't overload the CPU and also allows the bulb to reach the desired level after a change command I basically used wpskier solution in the above-mentioned link with few couple of changes:Īdded ability to send raw attribute data instead of target data in the original scriptĪbility to read level data and send back a calculated percentage that is bound directly to the dimmer control Maintain consistency between openhab and devices I run this script as a startup service using the service example by wpskier from here Although with LED bulbs energy usage is not much of an issue but waste any. So if someone does turn on the light locally after 6 hours it will get turned off. This script checks the status of each light and if there is a difference between the current status and the last status it sets the light bulb to the last status. One disclaimer I am not a Java programmer or unix shell script person, I get by hacking around other people's code and its my third day with openhab, so if you find something stupid would appreciate if you would point it out.Īlthough after a power failure GE Link bulbs turn on, however internally either in Wink or in the bulb the last "SET" state is remembered so leveraging that I sync the two states using a startup script based on the assumption that Wink will also reboot after a power failure. Wink "binding" without a binding !msg/openhab/pmrns4Yb8fM/BzqCJrpt7ycJįastest way to get a command to aprontest locally? I used a combination of approaches mainly from these two posts, many thanks to the original posters, since I have borrowed so many things then build up on them, I won't mention each idea. Waiting on X-10 USB RF controller to integrate the existing X-10 network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |